PSKoi - Walnut CA Pond Build

[Russell Peters]

The second Stainless Steel shower is on the wall in front of the filter pit. I used a solid bottom and put in seven bulkheads so that it can have a water fall / fountain built around it. Once the work is complete the pipes will be cut flush with the wall and sealed. The water will pour in just above the water line but below the fountain.

[Coolwon]

Those bottom cornices

Gunites the only way to go.

Garfield

[Russell Peters]

Day 2 - I hooked up the pumps to the SS Shower that is next to the deck. It is fed by two Periha PB25000 pumps. You can also see the sump pit, and the waste line, for the RDF's.

[Russell Peters]

Both RDF's were hooked up to the bottom drains and skimmers and the waste line is connected.

[Russell Peters]

The other RDF has three Periha PB 25000 pumps feeding the shower in front of it.

[Russell Peters]

The shower that is in front of the filter pit with the pipe extensions, on the bulk heads, and full of Bakki media.

[Russell Peters]

While I am doing this the guys finished the stone work on the path across the pond and started putting tile on the movie screen wall.

[Russell Peters]

Day 3 - Ran the pipes to the shower and got the spray bars made up.

[Russell Peters]

I spent some time hooking up the airlines and the lines that feed the fountains in the pond. These pipes were all over the place so I tried to get them as lined up as possible. I used a separate higher pressure pump for the fountains.

[Russell Peters]

Day 4 - Installed the pump controllers and the RDF controllers as well as the final piping from the pump to the fountain supply lines. The number "4" on the walls is for the electrical outlets.